Surge Protection - Point-of-Use


PRODUCTS
Surge Protection

Point-of-Use

Installing surge protection products at the electrical service entrance is an obvious place to start when needing power protection. However, in most cases, it’s not enough. Installing protection at distribution, branch panel boards, and specific sensitive loads or (Point of Use) equipment throughout your facility is the best way to prevent damage and eliminate associated downtime to sensitive microprocessor-based electronics.

The Edco ACP-340LED is an upgrade to the popular Edco ACP-340, adding a failure indicator as well as remote sensing circuitry. In addition, this unit offers much better lightning protection than the standard Edco ACP-340.
The Edco MOD-12 combines AC and Tip/Ring protection for Key/PBX Systems into one attractive, compact assembly. This innovative design creates an automatic ground window, thus eliminating the problem of ground potential difference.
The Edco SHA-1210 filtering surge protector absorbs power line noise and switching transients that other suppressors and RFI filters pass through. The Edco SHA-1210 can replace the RFI filter when high attenuation of noise above 25 MHz is not required.
The PowerSure FAS-120AC surge suppressor is designed to protect AC distribution panel circuits or 120V power supplies feeding sensitive electronic equipment.
Series connected high-frequency noise filter with transient protection.
Filtering surge protector that absorbs power line noise and switching transients that other suppressors and RFI filters pass through.
An advanced five-stage hybrid, solid-state power line protector.
Surge protection for highway lighting/street pole applications. The suppressor is encapsulated in a weatherproof enclosure that is installed right inside the pole.
The Edco SHA-1201 is specifically designed for type 170 Traffic Controller cabinets that require power neutral to remain isolated from cabinet earth ground. Protection is provided both between phase-to-neutral, and neutral-to-ground.
A FingerSafe 120VAC single-phase 2W+G, 30A surge suppressor/filter designed to shunt electrical type transients affecting the electrical distribution inside a traffic cabinet.
Provides excellent noise suppression over a large frequency range.
A 120VAC Single Phase 2W+G, 60A surge suppressor/filter designed to shunt electrical type transients affecting the electrical distribution inside a traffic cabinet.
Designed from the outset to withstand the NEMA transient specification.
Ideal protection against surges, transients and noise on the incoming AC power line.
Provides Active Tracking® filtering, for DC power loads to protect against spikes, transients, and noise.
A series-connected DIN/flange mount high-frequency noise filter/surge suppressor.
Two-stage design that provides superior protection for sensitive equipment and for ANSI/IEE c62.41 Location Category A applications.
The SHA Series provides surge protection for highway lighting/street pole applications. The suppressor is encapsulated in a weatherproof enclosure that is installed right inside the pole.
The Islatrol INXT120NL000-1 is a 120VAC, 60A, EMI/RFI filter. The INXT is a series-connected device designed to filter electrical type transients impinging on electrical distribution of a traffic control cabinet.