SURGE PROTECTION

Edco surge protection products guard sensitive instrumentation against what we refer to as ‘backdoor’ transients and noise. While high-voltage transients caused by lightning strikes may get more attention, the need to protect all susceptible low-voltage routes like cable, telephone/data lines from surges, spikes and transients is often overlooked. Keep the backdoor closed to unwanted transients. Rely on Emerson Network Power surge protection products.

Data High-speed data links between buildings or one part of a plant to another have become more common with the widespread use of smart transmitters and the increase in unmanned installations. Our surge protection devices are suitable for all process I/O applications with a choice of low resistance units, high bandwidth, and a variety of voltage variants.
	Edco DCB Series (with NTI Technology) Edco 5W8-30 (Access Control Protection Module) Edco CAT6-POE Series (CAT6 Power-Over-Ethernet) Edco CAT6-5PoE (Power-over-Ethernet) Edco HVCP-48-BNC (Video, Power, Data Protection) Edco LCDP Series (Data Circuit) Edco PC642 Series (Zone/Loop/Data) Edco RJA-RJD Series (RJ-45 Telephone/Data) Edco SPA-60B Series (120VAC Interconnect Signal) Edco SRA64 Series (AC Power Line Filter) Edco SRS-BIU-15 NEMA TS-2 Port 1 Protector
Din Rail The adjustable DIN mount feature allows for fast, convenient installation within any industrial control panel.
	Edco DRS Series (DC Power)
Panelmount (Facility-Wide) Protecting a facility with this parallel line is an excellent first line of defense in limiting high impulse transients to a level that is acceptable to most electronic equipment. These high-energy surge protection products are placed in parallel with panels that are susceptible to both externally and internally generated transients. Our wide range of products offers specific surge protection levels, voltage/phase configurations, and any mode protection requirement at any panel within your facility.
	Edco SHA-1230
Point-of-Use Installing surge protection products at the electrical service entrance is an obvious place to start when needing power protection. However, in most cases, it’s not enough. Installing protection at distribution, branch panel boards, and specific sensitive loads or (Point of Use) equipment throughout your facility is the best way to prevent damage and eliminate associated downtime to sensitive microprocessor-based electronics.
	Edco ACP-340  Edco ACP-340/540LED Edco HSP121BT-1RU Edco SHA-1201 Edco SHA-1210 Edco SHA-1230FS Edco SHA-1250 Edco SHA-1260 120VAC Edco SHA Series Edco SHP Series Single Phase Filter, 120VAC or 240VAC Edco SPA-100T (with NTI Technology)
Rackmount A series of full-line high quality transient voltage surge protection devices especially designed to protect sensitive rack-mounted electronics. These compact units provide reliable protection from a broad range of power problems while typically using only 1U of rack space.
	Edco RM-CAT6-POE Series Edco RM-CX06 RM Series
Signal Transmitters and sensors are widely used in highly exposed areas, where lightning damage is common. Emerson Network Power’s Signal Line products guard sensitive instrumentation against what we refer to as "back-door" transients.
	Edco CAT6-POE Series (CAT6 Power-Over-Ethernet) Edco CP-24 Edco CATV-DF Edco CATV-145A Edco CCTV-1 Edco CX Series Edco CX-HFN Edco EL-EDS Edco FAS-1 and FAS-2 Series Edco FAS-TEL-DOT Series Edco MPA Series Edco MRA-6LC-6 Edco PC642 Series Edco PHC Series Edco RJA-RJD Series Edco SHAS Series Edco SLAC Series Edco SPA-300 Edco SPA-303 120VAC Edco SRA-6LC Series Edco SRA16C-1 Series Edco SS64/SS65 Series Edco PLP-S Series (with NTI Technology) Edco TCS-T1 Series (with NTI Technology – Wireless)
Specialty Products Associated surge protection products for typical and non-typical applications or installations.
	Edco PLP-S Series (with NTI Technology) Edco SPA-100T (with NTI Technology) Edco TCS-T1 Series (with NTI Technology – Wireless)
Telecommunications Telecommunication lines are widely used in highly exposed areas, or in long runs between buildings. Left unprotected at the primary and secondary, the conductors used in telecommunication applications are highly susceptible to transient impulses. Our telecom surge protection products are suitable for primary, secondary, and security applications.
	Edco CAT6-5POE Edco EL-EDS Edco FAS-1 and FAS-2 Series Edco FAS-Tel and FAS-31XT Edco H Series Edco MGB Ground Rail Edco Net Series Edco OPX Series Edco PB Series Edco PC2-Tel Edco RJA-RJD Series Edco TBLK Terminating Assembly Edco TER Series Edco PLP-S Series (with NTI Technology) Edco SPA-100T (with NTI Technology) Edco TCS-T1 Series (with NTI Technology – Wireless)