PRODUCTS

Signal

Transmitters and sensors are widely used in highly exposed areas, where lightning damage is common. Emerson Network Power’s Signal Line products guard sensitive instrumentation against what we refer to as "back-door" transients.

Edco FAS-TEL-DOT
The Edco FAS-TEL-DOT is a single pair telephone protector that implements an advanced three-stage hybrid design. This unit addresses over-voltage transients with gas discharge tubes (GDT) and silicon breakover devices.
Edco PLP-S Series (with NTI Technology)
Provides isolated power loop circuit protection in applications where higher current is required, such as fire alarm and security systems. Non-degrading SADS will last the lifetime of equipment, ensuring uptime.
Edco SLAC Series Combined AC Power and Data-Signal Surge Protection
Suppressor specifically designed to protect electronic instruments used by the water/wastewater industries.
Edco SLCP Series
The Edco SLCP Series are four-wire modules designed to protect signaling line circuits (SLC). The device has 0 ohms of resistance and offers line to ground protection.
Edco PC642 Series (Zone-Loop-Data)
Employs three-stage hybrid technology to address overvoltage transients and sneak and fault current for phones, data/communication lines and transmitters.
Edco PHC Series Two-Pair Signaling Circuit Protector Surge Protection Device
Designed to protect two pairs of wires specifically for alarm and security systems where operating currents can be as high as 5 Amps.
Edco RJA-RJD Series (RJ-45 Telephone and Data)
Four-pair telephone/data line protectors that implement advanced two stage hybrid design. These units address over voltage transients with silicon breakover devices, while sneak and fault currents are mitigated with PTC technology, which consists of solid state resettable fuses.
Edco CATV-DF
Designed to protect sensitive electronic equipment from damage due to excessive voltage or currents generated by lightning or static build-up.
Edco CCTV-1 Closed Circuit TV Surge Protection
Specifically designed for lightning protection on closed circuit TV systems.
Edco CATV-145A
This product is designed to protect coaxial cable TV signal lines from lightning transients.
Edco COHP Series
Three-stage hybrid protectors for low voltage data and telecommunications applications.
Edco CX Series
Surge Protective Devices (SPDs) that address over-voltage transients with a primary Gas Discharge Tube (GDT), and secondary Silicon Avalanche Diode (SAD) components.
Edco CX-HFN
Surge protectors designed to protect sensitive electronic equipment from damage due to excessive voltage or currents generated by lightning or static build-up.
Edco EL-EDS
Suppressor kit intended for installation with electrical switching devices that are connected through a relay contact on typical access control panels.
Edco FAS-1 and Edco FAS-2 Surge Protection
Multi-stage single-pair or two-pair surge suppressors designed for high exposure applications.
Edco MPA Series Modular Output File Protector
Modular device intended for use on traffic control load relay outputs.
Edco MRA-6LC-6 Vehicle Loop Detection Protector
Designed for any traffic controller cabinet equipped with 6-position, 5.08mm spacing sockets wired in line with load relay outputs.
Edco SPA-300 Medium Duty 120 VAC - 1 Phase
Designed to protect sensitive electronic equipment such as traffic controllers, from high energy surges.
Edco SPA-303 120VAC Load Relay
Three-circuit protective device intended for use on traffic control load relay outputs.
Edco SRA-6LC Series Vehicle Loop Detector
Addresses over voltage transients on both Common and Differential modes with state-of-the-art silicon breakover devices.
Edco SRA16C-1 Vehicle Loop Detection
The Edco SRA16C-1 is a three terminal device, two of which are connected across the signal inputs of the detector for differential mode protection, and the third is grounded to protect against common mode damage.
Edco SS64 and SS65 Series
Multi-stage hybrid suppressors address over-voltage transients with gas tube and silicon avalanche technology.
Edco TCS-T1 Series (with NTI Technology)
Combines highly reliable, non-degrading Silicon Avalanche Diode (SAD) technology, along with high energy gas tube protection.
Edco™ SHAS Series Highway Lighting Protection
The Edco SHAS Series Highway Lighting Protector is a smaller version of the popular Edco SHA Series. It easily fits into a 3" x 5" hand hole and incorporates the use of TMOVs (MOVs with a thermal cutoff) and an LED.
Edco MOD-12 Key Systems
The Edco MOD-12 combines AC and Tip/Ring protection for Key/PBX Systems into one attractive, compact assembly. This innovative design creates an automatic ground window, thus eliminating the problem of ground potential difference.