Edco PHC Series Two-Pair Signaling Circuit Protector Surge Protection Device


PRODUCTS

Edco PHC Series
Two-Pair Signaling Circuit Protector
Surge Protection Device

Emerson Network Power > CALA > Products > By Type > Surge Protection > Signal > Edco PHC Series Two-Pair Signaling Circuit Protector Surge Protection Device

The Edco PHC Series is designed to protect two pairs of wires specifically for alarm and security systems where operating currents can be as high as 5 Amps. Electrically, the Edco PHC Series is a rugged series hybrid implementing a staged complement of MOVs, copper wound inductors and Silicon Avalanche Diodes. This design reduces series resistance to 0.2 Ohms per pair. These products are intended to mate with an Edco PCB1B-WKEY gold-plated female terminal connector.

The Edco PHC modules plug into a base assembly (Edco PCB1B), which can be mounted to any flat surface and should be located as close as practical to the protected equipment. Terminal 1 and/or terminal 10 should be connected to Building-Approved Ground with 12 or 10 gauge solid wire.

Optional DIN rail mounting clips (part #11604KIT-PC) are available.​

  • Three-stage protection
  • Differential protection
  • Common mode protection
  • Plug-in module
  • Continuous current up to 5 Amps
  • UL 497B listed
  • Requires Edco PCB1B-WKEY mounting base
  • PC642PTU (Pass Thru Unit) available for troubleshooting
  • Automatic recovery
  • 5 year warranty
Features

Flexibility:

  • Installs easily with plug-in design.

Higher Availability:

  • Responds quickly to protect connected data lines from incoming surges.
  • Reduces series resistance to 0.2 Ohms per pair.

Lowest Total Cost Of Ownership:

  • Protects your investment with a 5-year warranty.

Ideally Suited For:

  • Horns
  • Bells
  • Strobes
Benefits
  • Operating Voltage: 36-120 VDC
  • Clamping Voltage: 43-150 VDC
  • Operating Current: 5A
  • Peak Surge Current: 10 kA (8 x 20µs)
  • Frequency Range: 0 to 10 MHz
  • Insertion Loss: < 0.1 dB at 10 MHz
  • SPD Technology: MOV, SAD, w/Series Inductor
  • Connection Type: Terminal block w/compression lugs
                               Terminals accept up to 10 AWG
  • Operating Temperature: -40°C to +85°C
  • Dimensions (Inches): 3.7H x 1.75W x 2.375L (PHC + Mounting Base)
  • Weight: 8 oz
  • Certifications: UL 497B
Technical Specification
Surge Suppression Products
Contact our support department about your Surge Protection product.

Telephone: +1 607 721 8840
Toll-Free: +1 800 288 6169
Contact Support